The Primary Truss Strut Assembly is delivered to the job site after being welded together in the shop. The headset for the Primary Truss Strut will be attached to 7 structural members, as shown in the following two photos. At the base of the Primary Truss Strut Assembly is welded the Base Plate Knife Connector.
A seat is ground smooth and made level on top of the block wall in the LIving Room for installation of the Base Plate Knife Connector, shown in the following two photos.
The Base Plate Knife Connector is bolted to the block wall. The bolts are drilled and epoxied into the wall and will be allowed to cure before the remaining Cable Truss Assembly is installed tomorrow.
No comments:
Post a Comment